Filter
Top Products
Using Dell OpenManage Switch Administrator 83
Field Definitions
Fields which are user-defined can contain between 1 -159 characters, unless otherwise noted on the
OpenManage Switch Administrator web page. All letters or characters can be used, except
the following:
•\
•/
•:
•*
•?
•<
•>
•|
Accessing the Device Through the CLI
You can manage the device over a direct connection to the Terminal port or via a Telnet
connection. If access is via a Telnet connection, ensure that the device has an IP address defined
and that the workstation used to access the device is connected to the device prior to beginning
using CLI commands.
For information about configuring an initial IP Address, see "Initial Configuration".
NOTE: Ensure that the software has been downloaded to the device before using the CLI to remotely
access the device.
Terminal Connection
1
Power on the device and wait until the startup is complete.
2
When the
Console>
prompt displays, type
enable
and press <Enter>.
3
Configure the device and enter the necessary commands to complete the required tasks.
4
When finished, enter the
exit
Privileged EXEC mode command.
The session quits.
NOTE: If a different user logs into the system in the Privileged EXEC command mode, the current user is
logged off and the new user is logged in.