Dell 4400 Webcam User Manual


 
Adding Parts 87
13 See the documentation that came with the drive for instructions on
connecting a drive cable to the drive.
HINT: Your computer
uses cable-select drive
cables. This means that
the device connected to
the end connector of the
drive cable is the master
device and the device
connected to the middle
connector is the slave
device. Be sure the jumper
setting on the new device
is set for "cable select"
(see the documentation
that came with the drive
for information).
14
Connect your computer and devices to their electrical outlets, and
turn them on.
NOTICE: To connect a network cable, first plug the cable in to the network
wall jack and then plug it in to the computer.
15
Install any drivers required for the drive as described in the drive
documentation.
1 Ensure that all cables are connected, and fold cables out of the way.
2 Ensure that no tools or extra parts are left inside the computer.
3 Pivot the cover down and ensure that the release buttons click into
place.
NOTICE: To connect a network cable, first plug the cable in to the network
wall jack and then plug it in to the computer.
4
Connect your computer and devices to their electrical outlets, and
turn them on.
power cable
drive cable