Dell 6300 Laptop User Manual


  Open as PDF
of 143
 
Installing and Configuring SCSI Drivers 3-15
 )ROOR Z WKHLQVWUXFWLRQVWKDW DSSHDUR QWKHVFUHHQ3UHVV( QWHU!DW
HYHU\VFUHHQWRDFFHSW WKH(=6&6,GHIDXOWYDOXHV
If you accept all the default values, the EZ-SCSI utility copies the files from the
diskette to the c:\scsi directory. The EZ-SCSI utility creates this directory if the
directory does not already exist. The EZ-SCSI utility also adds command lines to
your system’s configuration files (autoexec.bat and config.sys) that will load the
required device drivers into memory when you boot your system.
 3UHVV(VF!WRFRQWLQXHDIWHUWKH(=6&6,XWLOLW\HQWHUVFKDQJHVWR\RXU
V\VWHPFRQILJXUDWLRQILOHV
If you want to copy the files to a different directory or control the changes to your
configuration files, follow the instructions on the screen. Press <F1> on any
screen to see more information.
NOTE: If the EZ-SCSI utility is unable to locate the
mscdex.exe
file in the
c:\dos
directory,
it will prompt for a pathname to access this file. Without this file, the
utility cannot access the system’s CD-ROM drive.
 :KHQWKHPHVVDJH(Adaptec EZ-SCSI has been successfully
installed…)DSSHDUVRQWKHVFUHHQSUHVV(QWHU!RU(VF!WRH[LWWKH
(=6&6,XWLOLW\DQGUHPRYHWKH$GDSWHF(=6&6,GLVNHWWHIURPWKH
GULYH7KHQUHERRW\RXUV\VWHPE\SUHVVLQJ&WUO!$OW!'HO!
,QVWDOOLQJ1HW:DUHDQG'ULYHUV
You need to install several updated drivers and Dell-supplied Novell patches when you
install the NetWare 4.11 operating system on your system for the first time.
To install the NetWare 4.11 operating system on your PowerEdge system, use the
.ham drivers that are provided on the
Dell Server Assistant
CD. You will need to
create driver diskettes from the CD if you have not already done so. See the next sec-
tion, “Creating the
Netware 4.11 Driver Updates
Diskette,” for instructions on
creating the driver diskettes from the
Dell Server Assistant
CD. For information about
installing the .ham drivers in NetWare 4.11, see “Installing NetWare 4.11” found later
in this document. To install the Dell-supplied Novell patches, see “Installing the Dell-
Supplied Novell Patches” found later in this document.
NOTES: If the server has a redundant array of inexpensive disks (RAID) controller
installed, you must set up the RAID controller and drives in a valid configuration
before
you perform the procedures in this section. Refer to the RAID controller docu-
mentation to configure the controller and drives, and then return to this section.
Before symmetric multiprocessing (SMP) can be installed on your system, you
must
apply the IntraNetWare Support Pack 4.0A to the NetWare 4.11 operating system.
See “Applying IntranetWare Support Pack 4.0A” found later in this document.
 previous next