Dell 6300 Laptop User Manual


  Open as PDF
of 143
 
Installing and Configuring SCSI Drivers 3-23
NOTE: To load the driver from your hard-disk drive, the
aic78u2.ham
driver and
nwaspi.cdm
module must be copied from your NetWare 4.11 driver diskette to a
directory on your hard-disk drive (usually, the server's start-up directory [for example,
c:\nwserver
]).
The syntax to load the aic78u2.ham driver follows:
load [
pathname
]\aic78u2.ham [
options
] slot=
x
For example, the command line to load the driver from the c:\nwserver directory with
the verbose= option on and a slot number of 10002 follows:
load c:\nwserver\aic78u2.ham verbose=y slot=10002
NOTE: For each Adaptec 78
xx
host adapter installed, a separate
load
command line
must be included in the
startup.ncf
file. The slot number (
slot=
) identifies the specific
adapter.
To modify the startup.ncf file, follow these steps:
 7\SHinstallDWWKH1HW:DUHSURPSWDQGSUHVV(QWHU!
 6HOHFWWKHDSSURSULDWHPHQXFKRLFHWKDWDOORZV\RXWRHGLWWKHVWDUWXSQFI
ILOH
 0DNHWKHQHFHVVDU\FKDQJHV:KHQ\RXDUHILQLVKHGSUHVV)!
8VLQJ5HPRYDEOH0HGLD
The aha2940.ham driver module fully supports removable-media disk drives, includ-
ing magneto-optical drives. Removable media is treated as a standard SCSI hard-disk
drive, with some exceptions:
The driver only recognizes and registers media with 512 bytes/sector.
NetWare allows you to mount or dismount the media and lock or unlock the
media.
These removable media options are supported by NetWare’s monitor.nlm program.
Follow these steps to set up the removable media:
 /RDGPRQLWRUQOPWRGLVSOD\WKHYDULRXVRSWLRQV
 6HOHFW'LVN,QIRUPDWLRQ
All system hard-disk drives appear.
 6HOHFWWKHUHPRYDEOHPHGLDGHYLFH
Drive status items appear as shown in Table 3-2.
 previous next