Dell 6300 Laptop User Manual


 
3-22 Dell PowerEdge 6300 Systems User’s Guide
To install the IntranetWare Support Pack 4.0A complete these steps:
 3ODFHWKH6XSSRUW3DFNILOHRQWRDZRUNVWDWLRQWKDWLVDWWDFKHGWRWKH
3RZHU(GJHVHUYHU
 &RS\WKHVXSSRUWSDFNILOHWRDYROXPHRQWKHVHUYHU
 ([SDQGWKHILOHE\W\SLQJiwsp4a.exeDQGSUHVV(QWHU!
 )ROORZWKHGLUHFWLRQVOLVWHGLQWKHLZV SDW[WILOHLQFOXGHGZLWKWKH
VXSSRUWSDFN
When Support Pack 4.0A has been applied, you can install SMP on your system.
,QVWDOOLQJ6036XSSRUW
To add SMP support to your NetWare 4.11 installation, use the following procedure:
 $WWKH1HW:DUHFRQVROHSURPSWW\SHLoad installDQGSUHVV
(QWHU!
 )URPWKHLQVWDOODWLRQVFUHHQWKDWDSSHDUVVHOHFW0XOWL&382SWLRQV
DQGSUHVV(QWHU!
 )URPWKHVHOHFWLRQVFUHHQVHOHFW6HOHFWD3ODWIRUP0RGXOHDQGSUHVV
(QWHU!
 )URPWKHQH[WVHOHFWLRQVFUHHQVHOHFW036360DQGSUHVV(QWHU!
A confirmation screen appears asking if you want to load the selected module.
 6HOHFW<HVDQGSUHVV(QWHU!
A message screen appears.
 ([LWWKHPHVVDJHVFUHHQVZLWFKWRWKHFRQVROHSURP SW GRZQWKHVHUYHU
DQGU HE RR WWKHV \ VWH P WRHQDEOH603 VXSSRUW
8VLQJVWDUWXSQFIDQGDXWRH[HFQFI
The startup.ncf and autoexec.ncf files contain a set of commands that are executed
during the boot routine. The startup.ncf file contains commands to load the disk driv-
ers. Once startup.ncf loads disk drivers, control is passed to the autoexec.ncf file to
complete the boot routine. For additional information on the startup.ncf and
autoexec.ncf files, refer to your NetWare documentation.
To automatically load the aic78u2.ham driver during the boot routine, the startup.ncf
file must contain a load command line that specifies the location of the driver on the
hard-disk drive. To find the slot number, type load a:\scsi\aic78u2.ham at the
console prompt and press <Enter>. A list of slot numbers is displayed separated by
commas. Press <Esc> to clear the command line.