Filter
Top Products
4-8 Dell PowerEdge 6300 Systems User’s Guide
6HWXS3 DVVZRUG
Setup Password lets you restrict access to your computer’s System Setup program in
the same way that you restrict access to your system with the system password fea-
ture. The settings are:
Not Enabled (the default)
Enabled
Disabled by Jumper (jumper removed)
NOTE: Read “Using the Setup Password Feature” found later in this chapter for
instructions on assigning a setup password and using or changing an existing setup
password. See “Disabling a Forgotten Password” found later in this chapter for
instructions on disabling a forgotten setup password.
0RXVH
Mouse
enables or disables the system’s built-in Personal System PS/2-compatible
mouse port. Disabling the mouse allows an expansion card to use IRQ12.
6HULDO3RUWDQG6HULDO3RUW
Serial Port 1 and Serial Port 2 configure the system’s built-in serial ports. These
options can be set to Auto (the default) to automatically configure a port, to a particu-
lar designation (COM1 or COM3 for Serial
Port
1; COM2 or COM4 for Serial Port 2), or
to Off
to disable the port.
If you set a serial port to Auto and add an expansion card containing a port configured
to the same designation, the system automatically remaps the built-in port to the next
available port designation that shares the same interrupt request (IRQ) setting as
follows:
COM1 (input/output [I/O] address 3F8h), which shares IRQ4 with COM3, is
remapped to COM3 (I/O address 3E8h).
Likewise, COM2 (I/O address 2F8h), which shares IRQ3 with COM4, is
remapped to COM4 (I/O address 2E8h).
NOTE: When two COM ports share an IRQ setting, you can use either port as neces-
sary,
but you may not be able to use them both at the same time
. If the second
port (COM3 or COM4) is also in use, the built-in port is turned off.
3DUDOOHO 3RUW
Parallel Port configures the system’s built-in parallel port. Parallel Port can be set to
378h
(the default), to alternate addresses 278h
or 3BCh, or to Off to disable the port.
NOTE: Do not set Parallel Port to 278h if you have an Extended Capabilities Port (ECP)
device connected to the port.