Filter
Top Products
10 Dell PowerConnect RPS-60 Setup Guide
www.dell.com | support.dell.com
Mounting Instructions
NOTICE: Before you install the PowerConnect™ RPS-60, consult the
User's Guide for your PowerConnect switch to confirm that your switch
supports the PowerConnect RPS-60 redundant power system.
The PowerConnect RPS-60 is an external redundant power system that
provides a second redundant power supply for your PowerConnect switch,
eliminating the power supply as a single point of failure. To use the RPS-60:
1 Attach the adapter tray to the back of the switch by tightening the two
mounting screws.
2 Insert the power adapter into the tray.
3 Plug the power adapter’s DC cable into the connector labeled "RPS"
on the back of the switch.
4 Connect the AC power cable to the power adapter, and then plug it
into an electrical outlet.
The switch is now using both power supplies simultaneously. You can
monitor the status of the two power supplies with the front-panel LEDs on
your PowerConnect switch.
Technical Information
Input Characteristics
Input voltage range 90 VAC to 264 VAC, single phase
Input frequency range 47 Hz to 63 Hz
Max. input AC current 1.5 A at 130 VAC; 1 A at 230 VAC
Inrush current (cold start) 50 A at 115 VAC; 100 A at 230 VAC
Efficiency 80% minimum at 115-VAC input full load
Output Characteristics
Static output characteristics (Vo)
Output voltage 12 V ± 5%
Load range minimum 0 A
Load range maximum 5 A
Peak (1sec) 6 A