Filter
Top Products
Installing System Components 65
Figure 6-10. Installing and Removing the Riser Board
Installing the Riser Board
CAUTION: See your System Information Guide for complete information about safety precautions,
working inside the computer, and protecting against electrostatic discharge.
1
Slide the riser board onto the system board. See Figure 6-10.
2
Tighten the two captive screws that secure the riser board to the system board. See
Figure 6-10.
3
Install any expansion card(s). See "Installing an Expansion Card."
4
Close the system. See "Closing the System" in Troubleshooting Your System."
Daughter Card
The system uses a daughter card to support software RAID. Hardware RAID systems do not use a
daughter card.
Removing a Daughter Card
1
Open the system. See "Opening the System" in Troubleshooting Your System."
2
Disconnect the hard-drive cables from the daughter card. See Figure 6-11.
captive screws (2)
riser board
D3835bk0.book Page 65 Monday, August 24, 2009 4:34 PM