Filter
Top Products
Installing System Components 69
Figure 6-12. Installing and Removing a Memory Module
Removing Memory Modules
CAUTION: See your System Information Guide for complete information about safety precautions,
working inside the computer, and protecting against electrostatic discharge.
1
Open the system. See "Opening the System" in Troubleshooting Your System."
2
Locate the memory module sockets. See Figure 6-1.
3
Press down and out on the ejectors on each end of the socket until the memory module pops
out of the socket. See Figure 6-12.
4
Close the system. See "Closing the System" in "Troubleshooting Your System."
Control Panel
The following procedure documents the steps for removing and replacing the control panel.
Removing the Control Panel
CAUTION: See your System Information Guide for complete information about safety precautions,
working inside the computer, and protecting against electrostatic discharge.
1
Turn off the system and attached peripherals, and disconnect the system from the electrical
outlet.
2
Dismount the system from the rack.
3
Remove the bezel.
alignment key
memory module
socket ejectors (2)
memory module
socket
D3835bk0.book Page 69 Monday, August 24, 2009 4:34 PM