Filter
Top Products
70 Installing System Components
www.dell.com | support.dell.com
a
Push the bezel release latches inward.
b
Pull the bezel away from the system.
4
Open the system.
a
Loosen the two captive screws at the back of the system.
b
While pressing down on the cover indention, slide the cover backward about an inch, and
grasp the cover on both sides.
c
Carefully lift the cover away from the system.
5
Remove all of the hard drive carriers in the system.
6
Label the hard drives with their locations in the hard drive bay.
7
Untwist the cable tie that holds the control panel cable and the LED cable together. See
Figure 6-13.
8
Press the release latches inward on each side of the control panel, and carefully slide the
control panel out of the system.
9
Disconnect the control panel cable and the LED cable from the control panel.
D3835bk0.book Page 70 Monday, August 24, 2009 4:34 PM