Filter
Top Products
Installing System Components 109
5
Lift the expansion-card latch and remove the filler bracket. See
Figure 3-16.
NOTE: To install an expansion card in the expansion-card connector on the
system board, go to step 7.
6
Holding the card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector.
7
Insert the card-edge connector firmly into the expansion-card connector
until the card is fully seated.
8
Replace the expansion-card latch. See Figure 3-16.
Figure 3-16. Installing and Removing an Expansion Card
1 expansion-card latch 2 expansion card
3 expansion-card connector
1
2
3
book.book Page 109 Wednesday, February 17, 2010 6:17 PM