Filter
Top Products
132 Installing System Components
4
If installed, remove the integrated storage controller card. See "Removing
the Integrated Storage Controller Card" on page 115.
CAUTION: To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
5
To remove the battery, support the battery connector by pressing down
firmly on the positive side of the connector.
6
Lift the battery out of the securing tabs at the negative side of the
connector.
7
To install a new system battery, support the battery connector by pressing
down firmly on the positive side of the connector.
8
Hold the battery with the "+" facing up and slide it under the securing
tabs at the positive side of the connector.
9
Press the battery straight down into the connector until it snaps into place.
10
If applicable, replace the integrated storage controller card. "Installing the
Integrated Storage Controller Card" on page 117.
11
Close the system. See "Closing the System" on page 77.
12
Reconnect the system to the electrical outlet and turn the system on,
including any attached peripherals.
13
Enter the System Setup program to confirm that the battery is operating
properly. See "Using the System Setup Program and UEFI Boot Manager"
on page 53.
14
Enter the correct time and date in the System Setup program's
Time
and
Date
fields.
15
Exit the System Setup program.
book.book Page 132 Wednesday, February 17, 2010 6:17 PM