Filter
Top Products
90 Installing System Components
Front-Chassis Assembly
The front-chassis assembly consists of the hard drives, SAS/SATA backplane,
optical drive, control panel assembly, and the front panel display. The front-
chassis assembly is mounted on the chassis walls with a sliding rail system.
To slide the front-chassis assembly away from the chassis:
1
If installed, remove the front bezel
. See
"Removing the Front Bezel" on
page 75.
2
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
3
Open the system. See "Opening the System" on page 76.
4
Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 88.
CAUTION: To prevent the memory modules from being damaged, ensure that all
cables connected to the front-chassis assembly are free of obstructions.
5
If required, free the power/data cables from the chassis walls.
6
If required, remove the SAS cables connected to the backplane. See
Figure 3-10.
7
Press the release tabs inward and slide the assembly forward and away from
the chassis. See Figure 3-10.
book.book Page 90 Wednesday, February 17, 2010 6:17 PM