Filter
Top Products
70 Using the System Setup Program and UEFI Boot Manager
Integrated Devices Screen
USB Flash Drive
Emulation Type
(Auto default)
Determines the emulation type for a USB flash drive.
Hard disk allows the USB flash drive to act as a hard
drive. Floppy allows the USB flash drive to act as a
removable diskette drive. Auto automatically chooses an
emulation type.
Auto automatically chooses the appropriate emulation
type for the device, except for devices installed in the
internal SD card slot. A device installed in the internal
SD card slot will automatically emulate a hard drive. If
you install a device in this slot that is configured as a
removable diskette drive, you must manually set the
emulation type to Floppy.
Boot Sequence Retry
(Disabled default)
If this field is enabled and the system has failed to boot,
the system will reattempt to boot after 30 seconds.
Option Description
Integrated SAS Controller
(Enabled default)
Enables or disables the integrated SAS controller.
User Accessible USB Ports
(All Ports On default)
Enables or disables the user accessible USB ports.
Options are All Ports On, Only Back Ports On, and All
Ports Off.
Internal USB Port
(On default)
Enables or disables the internal USB port.
Internal SD Card Port Enables or disables the internal SD card port.
Redundancy
(Disabled default)
Enables or disables the internal dual SD module mirror
mode.
Embedded NIC1 and
NIC2
(Enabled default)
Enables or disables the operating system interface of the
embedded NICs. The NICs can also be accessed through
the system's management controller.
Embedded NIC3 and
NIC4
(Enabled default)
Enables or disables the operating system interface of the
embedded NICs. The NICs can also be accessed through
the system's management controller.
Option Description
book.book Page 70 Wednesday, January 20, 2010 10:20 AM