38 Using Batteries and Module Bay Devices
www.dell.com | support.dell.com
2
Pull the device by the latch release to remove the device from the module bay.
3
Insert the new device into the bay, push the device until you feel a click, and push the device
latch release in so that it is flush with the computer.
Removing and Installing Devices While the
Computer Is Running
CAUTION: Before you begin any of the procedures in this section, read the safety instructions in your
Product Information Guide.
NOTE: If the device screw is not installed, you can remove and install devices while the computer is
running and connected to a docking device (docked).
1
Double-click the
Safely Remove Hardware
icon on the taskbar.
2
Click
Stop
and wait for the operating system to confirm that the device has stopped.
3
Click the device you want to eject.
NOTICE: To prevent damage to devices, place them in a safe, dry place when they are not installed in
the computer. Avoid pressing down on them or placing heavy objects on top of them.
4
Press the device latch release so that the latch release pops out.