Filter
Top Products
82 Adding and Replacing Parts
www.dell.com | support.dell.com
NOTICE: To prevent damage to the memory module connector, do not use tools to spread the inner metal
tabs that secure the memory module.
6
If you are replacing a memory module, remove the existing module.
NOTICE: Handle memory modules by their edges, and do not touch the components on a module.
a
Use your fingertips to carefully spread apart the securing clips on each end of the memory
module connector until the module pops up.
b
Remove the module from the connector.
NOTICE: If you need to install memory modules in two connectors, install a memory module in the
connector labeled "SLOT 1" before you install a module in the other connector.
7
Ground yourself and install the new memory module:
NOTE: If the memory module is not installed properly, the computer does not boot. No error message
indicates this failure.
a
Align the notch in the module with the slot in the center of the connector.
NOTICE: Only hold the module by the shorter, notched ends. Do not push on the longer, outer edge.
b
Holding the shorter, notched ends of the module, slide the edge of the module firmly into
the connector, and rotate the module down until you feel a click. If you do not feel the
click, remove the module and reinstall it.
8
Replace the cover and screw.
NOTICE: If the memory module cover is difficult to close, remove the module and reinstall it. Forcing the
cover to close may damage your computer.