Filter
Top Products
5. Gently pull the pull-tab on the bottom flex-cable connector to release the cable from the inverter board.
6. Squeeze the flex-cable release levers at either side of the top flex-cable connector, releasing the connector.
Removing the Display Hinges
1. Remove the display assembly (see Removing the Display Assembly).
2. Remove the display bezel (see Removing the Display Bezel).
3. Remove the display panel (see Removing the Display Panel).
4. Remove the four screws (two on each side) that secure the hinge to the display back.
5. Remove the hinges.
Back to Contents Page
NOTICE: To avoid damage to the computer when replacing the bottom flex cable, gently support the bottom of the inverter board with one finger as
you reseat the bottom flex-cable connector. Do not bend the inverter board.
1
pull-tab
2
back of display panel
3
flex cable
1
screws (2 each side)
2
display hinge (1 left, 1 right)