Filter
Top Products
4. Disconnect the antenna cables from the WLAN card.
5. Release the WLAN card by removing the securing screw.
6. Lift the WLAN card out of its system board connector.
Replacing a WLAN Card
1. Insert the WLAN card connector at a 45-degree angle into the system board connector labeled "WLAN."
2. Press the other end of the WLAN card down into the slot on the system board until the card clicks into place.
1
WLAN
card
2
M2 x 3-mm securing
screw
3
antenna cable connectors
(2)
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board, and
realign the card.
NOTICE: To avoid damage to the WLAN card, never place cables under the card.