Filter
Top Products
Back to Contents Page
Hard Drive
Dell™XPS™M1330ServiceManual
Removing the Hard Drive
Removing the Hard Drive
1. Follow the procedures in Before You Begin.
2. Turn the computer over.
3. Remove the four M3 x 3-mm screws and slide the hard drive away from the bay.
Replacing the Hard Drive
1. Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
2. Slide the hard drive into the bay.
3. Replace and tighten the four screws on the hard drive.
4. Install the operating system for your computer, as needed (see "Restoring Your Operating System" in your computer Owner's Manual).
5. Install the drivers and utilities for your computer, as needed (see "Reinstalling Drivers and Utilities" in your computer Owner's Manual).
CAUTION: If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the ProductInformationGuide.
NOTICE: To prevent data loss, turn off your computer (see Turning Off Your Computer) before removing the hard drive. Do not remove the hard drive
while the computer is on or in Sleep state.
NOTICE: Hard drives are extremely fragile. Exercise care when handling the hard drive.
NOTE: Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
NOTE: If you are installing a hard drive from a source other than Dell, you need to install an operating system, drivers, and utilities on the new hard
drive (see "Restoring Your Operating System" and "Reinstalling Drivers and Utilities" in your Owner's Manual).
NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge" in the
Product Information Guide).
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the connector.