Filter
Top Products
Monitoring and Logging System Information 267
Monitoring System Information and Configuring
Logging (CLI)
This section provides information about the commands you use to configure
information you use to monitor the Dell Networking N2000, N3000, and
N4000 series switches. For more information about these commands, see the
Dell Networking N2000, N3000, and N4000 Series Switches CLI Reference
Guide
at support.dell.com/manuals.
Viewing System Information and Enabling the Locator LED
Beginning in Privileged EXEC mode, use the following commands to view
system health and resource information and to enable the switch locator
LED.
Command Purpose
show system Display various system information.
show system power Displays the power supply status.
show system
temperature
Displays the system temperature and fan status.
show memory cpu Displays the total and available RAM space on the switch.
show process cpu Displays the CPU utilization for each process currently
running on the switch.
locate [switch
unit
]
[time
time
]
Enable the switch locator LED located on the back panel
of the switch. Optionally, you can specify the unit to
identify within a switch stack and the length of time that
the LED blinks.
Command Purpose
show system Display various system information.
show system power Displays the power supply status.
show system
temperature
Displays the system temperature and fan status.
show memory cpu Displays the total and available RAM space on the switch.