Filter
Top Products
162 Adding and Replacing Parts
NOTICE: When the hard drive is not in the Tablet-PC, store it in protective antistatic
packaging. See "Protecting Against Electrostatic Discharge" in the Product
Information Guide.
2
Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use
excessive force, you may damage the connector.
3
Place the hard drive into the hard drive bay, seating it firmly between the
hard drive alignment ribs in the base.
4
Connect the hard drive cable to the system board connector.
5
Insert the two metal tabs of the metal bracket under the metal clips in the
hard drive bay, then lower the bracket down over the hard drive.
6
Tighten the two captive screws on the metal bracket.
7
Use the
Operating System
media to install the operating system for your
Tablet-PC. (See "Using the Operating System Media" on page 151.)
8
Use the
Drivers and Utilities
media to install the drivers and utilities for
your Tablet-PC. (See "Using the Drivers and Utilities Media" on page 147).
Subscriber Identity Module (SIM) Card
NOTICE: To protect the SIM card from electrostatic discharge (ESD), do not touch
the SIM card connector. Also, take care when removing the card to slide the card
completely out of the metal tabs before lifting the card out of the slot. The card is
brittle and may easily break.
NOTE: The SIM card is located in the battery bay. You must remove the main
battery before you can access the SIM card.
Removing the SIM Card
1
Follow the procedures in "Before You Begin" on page 155.
2
Push in the SIM card, then release the card.
3
Pull the SIM card from the SIM card slot and place it to one side.
book.book Page 162 Tuesday, May 13, 2008 5:03 PM