Filter
Top Products
Adding and Replacing Parts 149
5
Release the
WWAN
card by removing the screw.
6
Lift the
WWAN card
out of its system board connector.
Replacing a WWAN Card
NOTICE: The connectors are keyed to ensure correct insertion. If you feel
resistance, check the connectors on the card and on the system board, and realign
the card.
NOTICE: To avoid damage to the WWAN card, never place cables under the card.
1
Insert the
WWAN
card connector at a 45-degree angle into the system
board connector labeled "WWAN".
2
Press the other end of the
WWAN
card down into the slot on the system
board until the card clicks into place.
3
Replace the M2 x 3-mm securing screw.
4
Connect the black antenna cable with a gray stripe to the connector
labeled "aux" (black triangle) and connect the white antenna cable with a
gray stripe to the connector labeled "main" (white triangle).
5
Secure unused antenna cables in the protective mylar sleeve.
6
Replace the cover and tighten the captive screw.
book.book Page 149 Tuesday, October 7, 2008 6:00 PM