Filter
Top Products
About Your System 17
Power Supply Indicators
The voltage selection switch on the back panel of the system allows you to
select one of two primary voltage inputs. Ensure that the switch is set to the
proper voltage according to Table 1-4.
For information on system power requirements, see "Technical Specifications"
in your Getting Started Guide.
Table 1-3. NIC Indicator Codes
Indicator Type Indicator Code Description
Activity Off When off at the same time that the link indicator
is off, the NIC is not connected to the network or
the NIC is disabled in the System Setup
program. See "Using the System Setup Program"
on page 31.
Blinking Indicates that network data is being sent or
received.
Link Off When off at the same time that the activity
indicator is off, the NIC is not connected to the
network or the NIC is disabled in the System
Setup program. See "Using the System Setup
Program" on page 31.
Yellow 1000-Mbps connection
Orange 100-Mbps connection
Green 10-Mbps connection
Table 1-4. Voltage Selection Switch
If your power source is: The voltage selection switch should be set to:
110 V
220 V
115
230
book.book Page 17 Wednesday, April 15, 2009 8:47 PM