Filter
Top Products
About Your System 29
Warning Messages
A warning message alerts you to a possible problem and prompts you to
respond before the system continues a task. For example, before you format a
diskette, a message will warn you that you may lose all data on the diskette.
Warning messages usually interrupt the task and require you to respond by
typing y (yes) or n (no).
NOTE: Warning messages are generated by either the application or the operating
system. For more information, see the documentation that accompanied the
operating system or application.
Warning! A fatal error
has caused system
reset!
Please check the system
event log.
A multibit ECC error
has occurred.
Run the system
diagnostics. See
"Running the System
Diagnostics" on
page 127.
Warning: The installed
memory configuration is
not optimal.
A DIMM configuration
is unsupported. The
installed memory
modules are not
matched pairs.
Reinstall the memory
modules and, if
necessary, replace them.
See "Troubleshooting
System Memory" on
page 114.
Write fault
Write fault on selected
drive
The operating system
cannot write to the
diskette drive or hard
drive.
See "Troubleshooting a
Diskette Drive" on
page 116 or
"Troubleshooting a Hard
Drive" on page 120.
<drive letter>
:\ is not
accessible. The device
is not ready.
The diskette drive
cannot read the
diskette.
Insert a diskette into the
drive or replace the
existing diskette, and try
again.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions
book.book Page 29 Wednesday, April 15, 2009 8:47 PM