Filter
Top Products
Preparing a system for conversion from tower mode to
rack mode
Prerequisites
1. Ensure that you read the Safety instructions.
2. Keep the #2 Phillips screwdriver ready.
3. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet and peripherals.
4. Lay the system on a flat, stable surface.
5. If installed, remove the system feet or caster wheels. For more information, see Removing the
system feet or Removing caster wheels.
6. Remove the system cover.
Steps
1. Remove the system top cover. For more information, see Removing the system top cover.
2. Remove the control-panel assembly. For more information, see Removing the control panel
assembly.
3. Install the rack slide cover by performing the following steps:
a. Slide the rack slide cover between the system's side cover and the chassis.
b. Slide the rack slide cover toward the back of the system until the tabs on rack slide cover locks
with the tabs extending from the chassis.
148