Filter
Top Products
Item Indicator, Button, or
Connector
Icon Description
5 System identification
button
The identification buttons on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the LCD panel on the front and the
system status indicator on the back flash until one
of the buttons is pressed again.
Press to toggle the system ID on and off.
If the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter the BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup),
press and hold for more than 15 seconds.
6 iDRAC Enterprise port Dedicated management port.
NOTE: The port is available for use only if the
iDRAC Enterprise license is installed on your
system.
7 Power supply (PSU1)
AC 495 W, 750 W, 1100 W, or
1600 W
or
DC 1100 W
8 USB connectors (6) Allows you to connect USB devices to the system.
Four ports are USB 2.0-compliant and two ports
are USB 3.0-compliant.
9 Video connector Allows you to connect a VGA display to the
system.
10 Serial connector Allows you to connect a serial device to the
system.
11 Power supply (PSU2)
AC 495 W, 750 W, 1100 W, or
1600 W
or
DC 1100 W
12 PCIe expansion card
slots full height (4)
(processor 2)
Connects up to four full-height PCI Express
expansion cards.
18