D-Link PM0599-03 Network Router User Manual


 
COPYRIGHT © 2006 MERIT INDUSTRIES, INC.
Programming the Router
Introduction
The broadband installer should have left a document describing specific information required
to connect to the Internet Service Provider (ISP). This document may have included a User
Name and Password and/or several IP addresses. An IP address is a number used to
identify an address on the Internet. This information will be used to program the router.
The software in the jukebox provides access to the router setup screens so that a laptop or
other computer is not required for setting up the router.
FIGURE 2-5 - ROUTER SETUP SCREEN
Description
Be sure the broadband equipment and the router are powered up and the proper status LEDs
on all equipment are lit. Power up the jukebox and wait for the User Interface to appear.
Open the jukebox and press the SERVICE button on the Communication Controller board to
enter the Service Mode. Touch the Hardware Setup button then touch Router Setup. The
screen should look like Figure 2-5. If you get a “Page Not Found” error screen, see
Troubleshooting for suggestions.
To change a value in the router, first touch the text box on the router setup view that is to be
changed. This sets the focus to that text box. Touch keys on the keyboard displayed at the
bottom of the screen to enter new data.
NOTE:
For security purposes several of the router configuration pages have
been disabled including the Setup Wizard and the HELP page. Full
access to all router configuration pages is still available but a laptop
computer or other computer device will have to be used. If the router
is configured using a different computer and the Administrator pass-
word is changed or the default IP address of the router is changed, you
will no longer be able to use the jukebox software to access and pro-
gram the router.
PM0599-03 MOD BOX INSTALLATION & OWNER’S MANUAL 22