D-Link PM0599-03 Network Router User Manual


 
COPYRIGHT © 2006 MERIT INDUSTRIES, INC.
CAUTION
MoD BoX must be solidly fastened to structural mem-
bers within the supporting wall.
MoD BoX weighs 130 pounds (50 kg); if it falls, it could
cause damage or injury.
INSTALLATION INSTRUCTIONS
INSTALLING THE HANGER BRACKET
NOTE: It is recommended that all wall installations or removals be performed by
two people for safety reasons.
NOTE: Before installing the MoD BoX on a wall, you should first install the hard
drive.
1. PREFERRED METHOD*: At the installation location, use a level to mark a horizontal line
that is exactly 64-3/8” (163.5 CM) off the floor. This will place the bottom of the MoD
BoX at the recommended 38” (965 cm) above the floor. Refer to Figure 1-1.
2. Using the level, mark another horizontal line which is 17" (43.2 cm) below the first line.
3. Locate the wall stud locations on the horizontal lines. Drill 5/32” holes at the marks.
Place the hanger against the wall and secure using the (4) 1/4” x 1-1/2” lag screws
supplied.
* In order to comply with the height requirements of ADA (Americans with Disabilities
Act), this line must be no more than 55-3/8” (140.6 cm) from the floor.
CAUTION
Supplied fasteners (1-1/2” lag screws) are for wood
wall stud construction. For other types of construc-
tion, installer must provide and use appropriate
fasteners.
PM0599-03 MOD BOX INSTALLATION & OWNER’S MANUAL 6