Filter
Top Products
Vigor2130 Series User’s Guide
39
3
3
.
.
1
1
.
.
2
2
P
P
o
o
r
r
t
t
s
s
Ports page is used to change the setting for WAN port. You can set or reset the following
items. All of them are described in detail below.
Port It displays current network interface.
Link It displays current connection status. Green light means the
WAN connection is successful.
Current It displays current speed that the router uses.
Speed Configured It can set the speed and duplex of the port. You can use the drop
down list to choose the required speed for the router. If you
have no idea in configuring speed, simple use the default setting,
Auto.
Flow Control If flow control is enabled by checking Configured box, both
parties can send PAUSE frame to the transmitting device(s) if
the receiving port is too busy to handle. If not, there will be no
flow control in the port. It drops the packet if too much to
handle.
Current Rx: indicates whether pause frames on the port are
obeyed.
Current Tx: indicates whether pause frames on the port are
transmitted.
Maximum Frame This module offers 1518~9600 (Bytes) length to make the long
packet for data transmission.
Excessive Collision Mode There are two modes for you to choose when excessive
collision happened in half-duplex condition.