Filter
Top Products
VigorSwitch P2260 User’s Guide
39
2
2
.
.
2
2
.
.
2
2
P
P
o
o
r
r
t
t
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
Port Configuration is applied to change the setting of each port. In this configuration
function, you can set/reset the following functions. All of them are described in detail
below.
Function name:
Port Configuration
Function description:
It is used to set each port’s operation mode. The switch supports 3 parameters for each port.
They are state, mode and flow control.
Parameter description:
State: Set the communication capability of the port is Enabled or
Disabled. When enabled, traffic can be transmitted and
received via this port. When disabled, the port is blocked
and no traffic can be transferred through this port. Port State
is configurable by the user. There are only two states
“Enable” and “Disable” able to choose. If you set a port’s
state “Disable”, then that port is prohibited to pass any
traffic, even it looks Link up.
Default: Enable.
Speed/Duplex: Set the speed and duplex of the port. In speed, 10/100Mbps
baud rate is available for Fast Ethernet, Gigabit module in
port 25, 26. If the media is 1Gbps fiber, it is always
1000Mbps and the duplex is full only. If the media is TP, the
Speed/Duplex is comprised of the combination of speed
mode, 10/100/1000Mbps, and duplex mode, full duplex and
half duplex. The following table summarized the function
the media supports.