Filter
Top Products
VigorSwitch P2260 User’s Guide
46
The switch will send out looping detection frame to detect the ports on the switch whether
they have looping traffic happen. When the switch port receives the looping detection
frame from itself, it means there is looping happen in the network. The looping ports will
be locked to avoid the looping storm causing all traffic be blocked.
Parameter description:
Port: User can set up the port (1~26) respectively to set loop
detection.
State: Enable or Disable the port loop detection. When it is enabled,
the port will send out loop detection frame and detect if any
loop happens. When it is disabled, the port can detect only
when the loop happens. Default: Disable.
Current Status: Show current status of this port. Unlocked means there is no
loop happened for this port. Locked means there is loop
happened in this port and that port is blocked.
Resume Action: You can use resume action to unlock the locked port when
you make sure the looping issue has been resolved. You also
can remove the locked port cable then reconnect the cable to
resume the locked port.
Action: Start loop detection.
2
2
.
.
5
5
S
S
N
N
M
M
P
P
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
Any Network Management System (NMS) running the Simple Network Management
Protocol (SNMP) can manage the Managed devices equipped with SNMP agent, provided
that the Management Information Base (MIB) is installed correctly on the managed devices.
The SNMP is a protocol that is used to govern the transfer of information between SNMP
manager and agent and traverses the Object Identity (OID) of the management Information
Base (MIB), described in the form of SMI syntax. SNMP agent is running on the switch to
response the request issued by SNMP manager.