Filter
Top Products
VigorSwitch P2260 User’s Guide
65
Then, click the <Apply> button, the system will take effect
immediately.
Join Time: Used to declare the Join Time in unit of centisecond. Valid
time range: 20 –100 centisecond, Default: 20 centisecond.
Leave Time: Used to declare the Leave Time in unit of centisecond. Valid
time range: 60 –300 centisecond, Default: 60 centisecond.
Leave All Time: A time period for announcement that all registered device is
going to be de-registered. If someone still issues a new join,
then a registration will be kept in the switch. Valid range:
1000-5000 unit time, Default: 1000 unit time.
Default Applicant Mode: The mode here means the type of participant. There are two
modes, normal participant and non-participant, provided for
the user’s choice.
Normal - It is Normal Participant. In this mode, the switch
participates normally in GARP protocol exchanges. The
default setting is Normal.
Non-Participant - It is Non-Participant. In this mode, the
switch does not send or reply any GARP messages. It just
listens messages and reacts for the received GVRP BPDU.
Default Registrar Mode: The mode here means the type of Registrar. There are three
types of parameters for registrar administrative control value,
normal registrar, fixed registrar and forbidden registrar,
provided for the user’s choice.
Normal - It is Normal Registration. The Registrar responds
normally to incoming GARP messages. The default setting
is Normal.
Fixed - It is Registration Fixed. The Registrar ignores all
GARP messages, and all members remain in the registered
(IN) state.
Forbidden - It is Registration Forbidden. The Registrar
ignores all GARP messages, and all members remain in the
unregistered (EMPTY) state.
Restricted Mode: This function is used to restrict dynamic VLAN be created
when this port received GVRP PDU. There are two modes,
disable and enable, provided for the user’s choice.
Disabled - In this mode, the switch dynamic VLAN will be
created when this port received GVRP PDU. The default
setting is Normal.
Enabled - In this mode, the switch does not create dynamic
VLAN when this port received GVRP PDU. Except received
dynamic VLAN message of the GVRP PDU is an existed
static VLAN in the switch, this port will be added into the
static VLAN members dynamically.