Eiki EIP-4500 Projector User Manual


 
94
Regarding the Lamp
Optional
accessories
Lamp unit 1
AH-45001
Removing and Installing
the Lamp Unit
Info
Make sure that you remove the lamp unit
by the handle. Do not touch the glass sur-
face of the lamp unit or the inside of the
projector.
To avoid injury to yourself and damage to
the lamp, be sure to carefully follow the
steps below.
Do not loosen other screws except for the
lamp unit cover and lamp unit.
(Only the silver screws are loosened.)
1 Press on the projector or
on the remote control to put
the projector into standby mode.
Wait until the cooling fan stops.
Warning!
Do not remove the lamp unit from the
projector right after use. The lamp and
parts around the lamp will be very hot
and may cause burn or injury.
2 Disconnect the power cord.
Unplug the power cord from the AC
socket.
Leave the lamp until it has fully cooled
down (about 1 hour).
3 Remove the lamp unit cover.
Loosen the user service screw (1) that
secures the lamp unit cover. Remove the
lamp unit cover (2).
STANDBY-ON button
Power cord
1
2
User service screw
Lamp unit 2
AH-45002