Filter
Top Products
3.3 Mounting the Tuba
The Tuba has been designed for two standard mounting options:
Attaching directly to the wall with screws
Mounting on a DIN rail
With either type of mounting, be sure to leave about 10 cm (4 in) above and below the
instrument for heat dissipation.
3.3.1 Mounting Directly onto Wall
The vertical mounting strip at the back of the Tuba enables you to screw the drive directly
into a wall.
To mount the Tuba with the mounting strip:
1. On the back of the drive, push the mounting strip up until it clicks and locks. The top lip
(with the hole) should be exposed.
Figure 3-1: Extending the Mounting Strip
Mount the Tuba vertically onto the wall with two screws, one through the top hole of the
mounting strip and one at the bottom.
Tuba Installation Guide Installation
MAN-TUBIG (Ver. 1.3)
3-5