Filter
Top Products
Fibre Channel FC4700 Array to IP4700 File Server Conversion Guide
15
Factory Initialization
Verify System Status 7. At the fcli > prompt, type ls and then press <Enter>.
Note: If the display indicates bound LUNs, you have “stale data” on disk 0.
Refer to the previous section, “Loading IP4700 Software,” for instructions as
you perform the following:
• Exchange disk 0 with another drive.
• (Make certain the new drive has never been in position 0, 1, or 2.)
• Power cycle the DPE.
• Copy the system image from disk 2 to disk 0.
• Begin again at Step 2 in this section.
8. At the fcli> prompt, type spstat and then press <Enter> as
shown on page 16.
fcli >ls
↵
ls: There are no currently bound units
03/29/2001 10:30:14 GMT
fcli >