Filter
Top Products
Aurorean Network Gateway-1100 User’s Guide 5
Chapter 2 Connecting Cables
Installation
Connecting Cables
Ethernet cables are used to connect the ANG-1100 to your computer or LAN
and the Internet. A serial cable can be used to connect the ANG-1105 to your
computer for diagnostic purposes.
All interconnections are made at the back of the ANG-1100 (refer to Figure 5).
Also, a reset button is located in the rear of the unit.
CAUTION
If you press the Reset button after you have configured your ANG-1100,
you will lose your entire configuration. Any settings you supplied must
then be re-entered. Do not use the Reset button unless you want the
configuration to return to factory defaults; you may want to record your
settings before using the Reset button.
Ethernet Connections
The ANG-1102 is equipped with two 8-pin modular RJ-45 Ethernet ports (five
ports on the ANG-1105) labeled TRUSTED and EXTERNAL as shown in
Figure 5. The trusted port is connected to a computer or hub/switch with
networked computers. The external port is connected to a cable or DSL
modem.
Figure 5 Location of the Serial/WAN/LAN Ports (ANG-1105 shown)
The trusted connection can be either a sole desktop computer or a hub that
connects up to 25 tunnels to the network as shown in Figure 6.
P
O
W
E
R
C
O
M
E
X
T
E
R
N
A
L
4
2
3
1
T
R
U
S
T
E
D
R
E
S
E
T