Filter
Top Products
22 Aurorean Network Gateway-1100 User’s Guide
Chapter 3
Configuring the ANG-1100 with Aurorean Web Config
– Set the Secondary DNS IP address.
– Click Apply.
! Click the PPPoE assigned IP address radio button and perform
the following steps:
– Specify a Username supplied by your cable/DSL provider.
– Enter a Password.
– Type the password again in the Confirm field.
– Click Apply.
3 If you chose the Manual or PPPoE options, a window appears
detailing the reconfiguration changes and prompting you to reboot the
ANG-1100. Click Reboot Now.
After a few moments when an IP address has been received for the external
port, the Internet LED will turn on. If a static IP address was configured, the
Internet LED will shine immediately.
NOTE
If you press the Reset button after configuring your ANG-1100, you will
lose your entire configuration. Any settings you supplied must then be
re-entered. Do not use the Reset button unless you want the configuration
to return to factory defaults. Also, you may want to record your
configuration settings.