Filter
Top Products
10 Aurorean Network Gateway-1100 User’s Guide
Checking ANG-1102/1105 Connections Chapter 2
Installation
Checking ANG-1102/1105 Connections
The ANG-1100 is now connected and ready for configuration. Check the
LEDS in the manner described below to confirm that the connections are
working properly.
LED behavior
The LEDs behave as follows at when powered up at startup:
! Power LED stays ON for 2-3 seconds indicating boot diagnostics are
running followed by boot up of the Linux kernel.
– If the Power LED flashes at a twice per second interval, boot
diagnostics have failed.
– If the Power LED remains ON or OFF following the boot
sequence, the kernel has failed to boot.
! Power LED blinks once per second indicating the system is operating
correctly.
! LAN LEDs 1-4 either blink when active or remain ON. The ANG-1102
LAN LEDs are amber (10 Mbps); the ANG-1105 LAN LEDs are green
(100 Mbps) or amber if the connected device is running at 10 Mbps.
! The WAN LED either blinks when active or remains ON.
! The VPN LED stays ON when a tunnel is connected.
The ANG-1100 is now ready for configuration. Refer to Chapter 3 for detailed
instructions.