Filter
Top Products
Aurorean Network Gateway-1100 User’s Guide 19
Chapter 3
Configuring the ANG-1100 with Aurorean Web Config
9 Optional. Check the Start network gateway now checkbox and click
Apply to create instant access or wait until the other end of the
connection is created.
10 Optional. Click Force default route under Global VPN Settings.
Force default route disables the ANG-1100’s Intelligent Client Routing
(ICR) feature which allows users to browse the Internet outside the
tunnel. Be aware that with Force Default enabled, the ANG-1100
transmits all traffic through the tunnel which may cause Web
browsing problems. This feature works with only one tunnel up and
running; it is disabled if you create more than one tunnel.
11 Click Apply.
After applying your changes, a VPN Setup update window appears
displaying configuration revisions.
NOTE
Now that you have set up a site-to-site connection, configuration is
complete unless you want to change the default Internet, LAN, Firewall,
Password default values or your service is a Digital Subscriber Line (DSL)
which requires that you configure a PPPoE connection (refer to “Setting
Up the Internet Connection” on page 20). Some cable internet providers
also require that you specify a MAC address (refer to “Using Advanced
Utilities” on page 35 for more information).
NOTE
If you press the Reset button after configuring your ANG-1100, you will
lose your entire configuration. Any settings you supplied must then be
re-entered. Do not use the Reset button unless you want the configuration
to return to factory defaults. Also, you may want to record your settings.