Filter
Top Products
6 Aurorean Network Gateway-1100 User’s Guide
Connecting Cables Chapter 2
Installation
Connecting an ANG-1102/1105
The ANG-1100 is typically set up in the configuration shown below.
Figure 6 Connecting the ANG-1100
To connect the ANG-1100 Ethernet port, perform the following steps:
1 Do one of the following as shown in Figure 7:
– If you are connecting an ANG-1102 to a hub, plug one end of a
straight-through Ethernet cable into the ANG’s trusted port. If
you are connecting an ANG-1105 to a PC, plug one end of a
straight-through cable into the ANG’s trusted port. If you are
connecting an ANG-1105 to a hub, plug one end of the red, cross-
over cable to a trusted port. Go to Step 2.
– If you are connecting the ANG-1102 directly to a computer, attach
one end of the red, cross-over cable to a trusted port and the other
end to an RJ45 connector on your computer. Skip to Step 3.
2 Plug the opposite end of the cable into a wall jack, patch panel, or hub
linked to a protected network segment.
Aurorean Network
Trusted (LAN)
connection
External (WAN)
connection
or
Hub
INTERNET
Site-to-site tunnel
ANG-3000/7000
User
User
Users
Cable / DSL
Modem
Gateway-1100
Site-to-site tunnel
Internet connection
Trusted connection