Filter
Top Products
18 Aurorean Network Gateway-1100 User’s Guide
Chapter 3
Configuring the ANG-1100 with Aurorean Web Config
CAUTION
When using PPTP, which selects MS-CHAPv2 authentication as a default,
a Username cannot contain a plugin selector (e.g., user@domain). For
example, if Windows 2000’s IAS is being used to authenticate PPTP
tunnels via a RADIUS plugin, the plugin must be the authorization's
default plugin.
5 Enter the Password on the remote ANG-3000/7000.
6 Confirm the password on the remote ANG-3000/7000.
7 Select the Connection type: either EZ-IPsec or PPTP.
The EZ-IPsec feature provides one-button configuration for standard
IPSec with IKE tunnels connecting to an ANG-3000/7000.
8 Select one of the following Connection modes:
– Client - standard site-to-site connectivity.
– Network Extension - expanded connectivity to devices on the
trusted network behind the ANG-1100.
CAUTION
Choosing Network Extension mode requires that you configure, in the
LAN Setup window, the IP address and mask with unique values
supplied by your Network Administrator. You cannot select NEM and
enable the ANG-1100 without your administrator’s approval.
– Peer to Peer - connectivity for devices on remote networks over
tunnels between two ANG-1100 servers, or interoperability
between an ANG-1100 and a Cisco, Nortel or Nokia/Checkpoint
VPN gateway. This option requires adding the IP address and
Subnet Mask of up to 3 remote peers.
NOTE
Choosing Peer to Peer mode requires that you configure one or more IP
addresses and subnet masks of connected peers with values supplied by
your Network Administrator.