Filter
Top Products
Using the Projector
23
4. Press the red
Power
button on top of the projector.
The power light flashes green as the projector warms up, and the
projection lamp comes on in about 30 seconds. The power light
stays green, and you may see a blue screen with the
No Signal
message displayed. This is normal.
5. Do one of the following:
■
Turn on or restart your computer. In a few moments, you
should see your computer display projected.
(Windows only: If you see a New Hardware Found message
saying that it has found a plug-and-play monitor, click
Cancel
.)
■
If you’re projecting a video, press the
Play
button on your
video source.
If a projected image fails to appear, see the next section for help.
Once you see your image, turn to page 26 for instructions on focusing
and making other image adjustments.
When you’re done with your presentation, shut down the projector as
described on page 30. Shutting down the projector correctly prevents
premature lamp failure and possible damage to the projector from
overheating.
Power
Power button
power light
warning
Never look into the lens when
the lamp is on. This can
damage your eyes, and is
especially dangerous for
children.
5600 and 7600.book Page 23 Thursday, December 14, 2000 2:46 PM