Filter
Top Products
84
Connecting to Additional Equipment
To use the adapter, remove its cover as
shown and set its DIP switches according
to the resolution you want to use, such as
16-inch mode. See your Macintosh
documentation for instructions.
Replace the cover and connect the
adapter to the free end of the computer
video cable. Then plug the cable (with
the adapter) into the video port on your
Macintosh.
4. Tighten the screws on the connectors.
Connecting the Mouse Cable
To use the remote control as a mouse follow the steps below. If the
Macintosh has a USB port, you can use the USB mouse cable
included with the projector. If it has a round mouse port, you’ll need a
Macintosh mouse cable; see your projector dealer for help in obtaining
the correct cable.
1. Connect the round end of the USB mouse cable (or a Macintosh
mouse cable) to the projector’s
Mouse
port.
Mouse port
USB mouse cable
5600 and 7600.book Page 84 Thursday, December 14, 2000 2:46 PM