Filter
Top Products
Fine-tuning the Projector
47
■
Tint (video only)
Adjusts the balance of green to magenta in the image.
■
Sharpness
Adjusts the sharpness of the image.
■
Gamma
Choose
Dynamic
for computer images with bright colors
(such as charts or graphs), or
Natural
to enhance video
images.
■
Resolution (computer images only)
Leave this setting at
Auto
to allow the projector to detect the
video signal automatically. If the projector is unable to sync
up with the computer, select
Manual
and choose one of the
settings.
■
Video Signal
Leave this setting at
Auto
unless you are using a 60-hertz PAL
system (select
PAL60
).
4. When the image is set correctly, press
Esc
. Your settings are
automatically saved.
Saving and Recalling Computer Settings
When you are projecting from a computer source, you can save and
recall settings (resolution, tracking, sync signal, and position) in up to
five different combinations. This is useful if you use more than one
computer with the projector; you can save the settings for each one
and recall them when necessary. Follow these steps to save the
projector’s current settings:
1. Press the
Menu
button to display the Main menu.
2. Press
Enter
to select the Video menu.
3. Use the down arrow (control panel) or
Enter
button (remote
control) to move down to the
Preset
option and press
Enter
. You
see the Preset Selection menu with the current resolution setting
displayed.
5600 and 7600.book Page 47 Thursday, December 14, 2000 2:46 PM