Filter
Top Products
80
Connecting to Additional Equipment
Connecting to a PC Desktop Computer
You can connect the projector to any IBM-compatible PC. This
section includes instructions for the following:
■
Connecting the computer cable
■
Connecting the mouse cable (if you want to use the remote
control as a mouse)
■
Connecting the audio cable (if you’ll be projecting with audio)
Follow the steps in each section for the cables you need to connect.
Before beginning, make sure the projector and computer are turned
off. If you need help with positioning the projector, see page 10.
Connecting the Computer Cable
1. Disconnect the monitor cable from the video port on the back of
the computer and set it aside. (You won’t be able to use the
monitor while the projector is connected.)
2. Connect one end of the computer cable to the projector’s
Computer 1
(analog) port, as shown.
3. Connect the other end of the cable to the computer’s video port.
4. Tighten the screws on the connectors.
computer cable
Computer 1 port
5600 and 7600.book Page 80 Thursday, December 14, 2000 2:46 PM