Filter
Top Products
36 Making Detailed Adjustments
■ Mosquito NR
Note: This setting cannot be used when the Color Mode is set to x.v.Color (see page 27) or
with a signal input through the PC port.
This setting reduces grainy noise that can appear around the edges of MPEG images. You
can select from 3 levels.
■ Block NR
Note: This setting cannot be used when the Color Mode is set to x.v.Color (see page 27) or
with a signal input through the PC port.
This setting reduces block noise that can appear when projecting MPEG images that have
been compressed at a low bit rate.
■ Frame Interpolation
This setting compares the current and previous frames, then creates a frame between
them to reduce fuzziness and produce clearer moving images. You can select from 3 levels
of frame interpolation. You can also access this setting by pressing the
Frame Int
button
on the remote control.
Color Settings
If the image colors don’t look correct, you can adjust them using these settings. Use the first
three settings described below to make the most visible changes. If you only need to make
slight adjustments, you can fine-tune the picture with the remaining settings. Most color
settings are stored separately for each image source and color mode.
Note: If you’re using a commercially available color calibration DVD, you can display a color-bar
test pattern and then filter colors in the image by pressing the Pattern button. Select one of the
Color Isolation options for the color you want to filter (R/G/B). This lets you adjust color settings
without holding a filter over your eyes while making adjustments. Press the Esc button when
you’re done.
■ Color Saturation
Note: This setting cannot be used when the Color Mode is set to x.v.Color (see page 27) or
with a signal input through the PC port.
Adjusts the color intensity of the image.
Signal > Advanced > Mosquito NR
Signal > Advanced > Block NR
Signal > Frame Interpolation
Image > Color Saturation