Filter
Top Products
10
EpsonNet WebAssist 199
10
10
10
10
10
10
10
10
10
10
10
❏ When Auto is selected, DHCP becomes available. To use the
DHCP server, make sure it is installed on your computer and
correctly configured. See your operating system’s online help
for detailed instructions.
❏ If Set Using Automatic Private IP Addressing (APIPA)
is enabled, a private IP address is automatically assigned to the
print server even when there are no DHCP servers on your
system or your network.
❏ If the Dynamic DNS function is not supported, we recommend
that you select Manual and then enter an IP address. If you
select Auto, the IP address of the print server changes every
time you turn on the printer, and you need to change the printer
port setting accordingly.
5. To assign an IP address manually, enter the IP address, the
subnet mask, and the default gateway. Be sure the IP address
does not conflict with any other devices on the network.
Note:
If there is a server or a router functioning as a gateway, enter the IP
address of the server or the router for the gateway address. If there
is no gateway, leave the default values there.
6. If you want to get a private address between 169.254.1.1 and
169.254.254.254 automatically when an IP address cannot be
obtained by the DHCP server, leave it at Enable for Set Using
Automatic Private IP Addressing (APIPA).
7. When setting an IP address using the ping command, select
Enable for Set Using PING. Select Disable when setting an
IP address with EpsonNet WinAssist/MacAssist/WebAssist;
this prevents any unexpected change of the IP address.
Note:
Be sure to select Disable when not using ping; this prevents an
unexpected change of the IP address by EpsonNet WebManager.