Filter
Top Products
10 Introduction
Before you start configuring the print server, be sure to press and
hold down the status sheet button on the print server for one to
two seconds to print a status sheet. A status sheet provides
important information about the print server, such as MAC
address, printer settings, and the printer’s current status. Press
the status sheet button once to print a simple status sheet, or twice
to print a full status sheet. You cannot print a status sheet when
the printer has already started printing, or when it is offline or not
ready to print.
Note:
If the printer does not print a status sheet, make sure the printer is online
and no print jobs are being processed, and then wait a minute. If it still
does not print a status sheet, turn the printer off, wait until the status
lights go out, and then turn it back on again. The status sheet can be
printed one minute after the printer finishes warming up.
c
Caution:
After turning off the printer, wait until the status lights go out
before turning the printer back on; otherwise, the print server may
not work correctly.
10/100 connector
This connector is used to connect an Ethernet cable to the network.
You can use this cable for both 10Base-T and 100Base-TX.
c
Caution:
You must use a Category 5 shielded twisted-pair cable to connect
the print server to prevent malfunction.
DCIN connector
Plug the AC adapter into the print server’s DC-IN connector.
c
Caution:
You must use the AC adapter shipped with this package.