Two or more sheets feed at one time.
You may have loaded too many sheets in the cut-sheet feeder’s bin.
You may have forgotten to fan the stack of paper before loading it
into the bin. Remove the paper and fan it.
The paper feed is crooked.
The paper may be old or creased. Use only new, clean sheets of
paper.
There may be too much paper in the stacker.
Make sure that the paper guides are set correctly and that your
paper is the proper size and quality. See the Appendix for paper
specifications.
One page of printing has spread to two pages.
Check that the page-length setting and lines-per-page setting in
your software are correct. See “Getting the results you expect” on
page 2-6.
Switching between the cut-sheet feeder and the push
tractor does not work properly
The desired paper type does not load.
The paper-release lever may not be in the proper position. Pull the
lever forward to load continuous paper or push the lever back to
load single sheets.
R
Blueberry REV.D
A5 size Chapter 3
95/01/20
Troubleshooting 3-9