Filter
Top Products
Using DISKCOPY with the Apex 100\20
1.
Make sure the diskette you want to copy is write-protected.
(See Chapter 2 for instructions.)
2.
If necessary, type
C
: to log onto drive C.
3.
At the
C>
prompt, type the following and press
Enter:
DISKCOPY A: A:
MS-DOS displays this message:
Insert SOURCE diskette in drive A:
Press any key when ready . . .
4.
Insert the diskette you want to copy from (the source) in
the diskette drive and press any key. DISKCOPY copies the
contents of the diskette to the computer’s memory. Then
the screen displays this message:
Insert TARGET diskette in drive A:
Press any key when ready . . .
5.
Remove the original diskette from drive A and insert the
blank diskette (the target) in the drive. Press any key. If the
new diskette is not formatted, DISKCOPY formats it and
then copies the contents of memory to the diskette. When
the copy is complete, you see this message:
Copy another diskette (Y/N)?
6.
Press
Y
and
Enter
to copy another diskette or
N
and
Enter
to return to the MS-DOS command prompt.
Using MS-DOS With Your Computer
3-31